Zeta Fire Detection

Fifteen different modes of detection. A sounder, a strobe and an isolator all-in-one device. Different alarm responses for each mode. Fire and faults decisions made by detector. Multi-stage alarms. Nuisance alarm filter. Led indication. System compatibility Zeta NET Fire Alarm System. Sounder / Strobe: 3 volumes / 7 tones, 5 ms flash per second. Sounder range: 75 dba (low), 92 dba (high).

Ammonia gas detector. Can be used either in a stand-alone mode or connected to Zeta Alarm Systems MGC 126 Multiple Gas Controller addressable panel. Range: 0-1000 ppm. Electrochemical sensor. Colour coded for ease of identification. Three programmable alarm levels (indicated by relay outputs) and a 24 V alarm output. Sensor life: 3 years. Operating temperature: 0 - 50°C. Size mm: 130 x 170 x 70.

Benzene gas detector. Detector can be used either in a stand-alone mode or connected to Zeta Alarm Systems MGC 126 Multiple Gas Controller addressable panel. Flammable gas is detected by the catalytic sensor fitted in the lower housing of the device. LEL (%): 1.3. Colour coded for ease of identification. Three programmable alarm levels (indicated by relay outputs) and a 24 V alarm output. Sensor life: 5 years. Operating temperature: 0 - 50°C. Size: 130 x 170 x 70.

Methanol gas detector. Can be used either in a stand-alone mode or connected to Zeta Alarm Systems MGC 126 Multiple Gas Controller addressable panel. LEL (%): 6.7. Range: 0-100% LEL. Alarm levels: 10-50% LEL. Electrochemical sensor. Colour coded for ease of identification. Three programmable alarm levels (indicated by relay outputs) and a 24 V alarm output. Sensor life: 5 years. Operating temperature: 0 - 50°C. Size: 130 x 170 x 70.

Acetone gas detector. Can be used either in a stand-alone mode or connected to Zeta Alarm Systems MGC 126 Multiple Gas Controller addressable panel. LEL (%): 2.6. Range: 0-100% LEL. Alarm levels: 10-50% LEL. Electrochemical sensor. Colour coded for ease of identification. Three programmable alarm levels (indicated by relay outputs) and a 24 V alarm output. Sensor life: 5 years. Operating temperature: 0 - 50°C. Size: 130 x 170 x 70.

Four-loop soft addressable, networkable fire alarm system. Two hundred addresses per loop. Network capacity of 8 panels. Fully configurable system with all its zones and I/O functions programmable. The panel can be supplied with 1, 2, 3 or 4 loop interfaces, and has an optional built-in printer. ZetaNET Repeater is also available. Loop detector contains a smoke sensor. Complies with European standards. Multi-stage alarms. Nuisance alarm filter. Operating voltages: 40 V / 20 V DC.

Ammonia gas detector. Can be used either in a stand-alone mode or connected to Zeta Alarm Systems MGC 126 Multiple Gas Controller addressable panel. Range: 0-5000 ppm. Electrochemical sensor. Colour coded for ease of identification. Three programmable alarm levels (indicated by relay outputs) and a 24 V alarm output. Sensor life: 3 years. Operating temperature: 0-50°C.Size mm: 130 x 170 x 70.

Nitrogen dioxide gas detector. Can be used either in a stand-alone mode or connected to Zeta Alarm Systems MGC 126 Multiple Gas Controller addressable panel. Range: 0-20 ppm. Electrochemical sensor. Colour coded for ease of identification. Three programmable alarm levels (indicated by relay outputs) and a 24 V alarm output. Sensor life: 3 years. Operating temperature: 0 - 50°C. Size (mm): 130 x 170 x 70.

Ethyl acetate gas detector. Detector can be used either in a stand-alone mode or connected to Zeta Alarm Systems MGC 126 Multiple Gas Controller addressable panel. Flammable gas is detected by the catalytic sensor fitted in the lower housing of the device. LEL (%): 2.2. Colour coded for ease of identification. Three programmable alarm levels (indicated by relay outputs) and a 24 V alarm output. Sensor life: 5 years. Operating temperature: 0 - 50°C. Size: 130 x 170 x 70. Size: 130 x 170 x 70.

Ethylene gas detector. Can be used either in a stand-alone mode or connected to Zeta Alarm Systems MGC 126 Multiple Gas Controller addressable panel. Range: 0-100% LEL. Alarm levels: 10-50% LEL. Electrochemical sensor. Colour coded for ease of identification. Three programmable alarm levels (indicated by relay outputs) and a 24 V alarm output. Sensor life: 5 years. Operating temperature: 0 - 50°C. Size: 130 x 170 x 70.

Isopropyl gas detector. Can be used either in a stand-alone mode or connected to Zeta Alarm Systems MGC 126 Multiple Gas Controller addressable panel. LEL (%): 2.2. Range: 0-100% LEL. Alarm levels: 10-50% LEL. Electrochemical sensor. Colour coded for ease of identification. Three programmable alarm levels (indicated by relay outputs) and a 24 V alarm output. Sensor life: 5 years. Operating temperature: 0 - 50°C. Size: 130 x 170 x 70.

Methy ethyl ketone gas detector. Can be used either in a stand-alone mode or connected to Zeta Alarm Systems MGC 126 Multiple Gas Controller addressable panel. LEL (%): 1.9. Range: 0-100% LEL. Alarm levels: 10-50% LEL. Electrochemical sensor. Colour coded for ease of identification. Three programmable alarm levels (indicated by relay outputs) and a 24 V alarm output. Sensor life: 5 years. Operating temperature: 0 - 50°C. Size: 130 x 170 x 70.

Input/output unit used to interface external equipment to any Zeta addressable fire alarm system. Switch monitoring input with a 47K end-of-line resistor and a volt-free SELV relay output. Built in loop short circuit isolator to help keep the unit operational in case of a problem. Three indication LEDs on the front of the unit. Operating voltage: 17 - 33 V DC. Operating temperature: 0ºC to 50ºC. Size: 127 x 88 x 59 mm. Weight: 220 g.

Flammable ethanol gas detector. Detector can be used either in a stand-alone mode or connected to Zeta Alarm Systems MGC 126 Multiple Gas Controller addressable panel. Flammable gas is detected by the catalytic sensor fitted in the lower housing of the device. LEL (%): 3.3. Colour coded for ease of identification. Three programmable alarm levels (indicated by relay outputs) and a 24 V alarm output. Sensor life: 5 years. Operating temperature: 0 - 50°C. Size: 130 x 170 x 70. Size: 130 x 170 x 70.

Interface external equipment with volt-free normally open relay output to any Zeta addressable fire alarm system. Input is monitored with a 47 K end of line resistor. Built in loop short circuit isolator. Internal LED indications for loop isolator. Operating voltage: 17 - 33 V DC. Operating temperature: 0ºC to 50ºC. Size: 127 x 88 x 57 mm. Weight: 220 g. 

Oxygen gas detector. Can be used either in a stand-alone mode or connected to Zeta Alarm Systems MGC 126 Multiple Gas Controller addressable panel. Range: 0-25%. Electrochemical sensor. Colour coded for ease of identification. Three programmable alarm levels (indicated by relay outputs) and a 24 V alarm output. Sensor life: 3 years. Operating temperature: 0 - 50°C. Size mm: 130 x 170 x 70. Operating temperature: 0 - 50°C. Size (mm): 130 x 170 x 70.

Ideal entry-level fire alarm panel for small premises. Low cost and simple installation. For larger systems, 4 zone, 6 zone and 8 zone versions are also available. Detection zones: 2. Sounder output: 2 x 400 mA. System voltage: 24 V DC (nominal). Operating temperature: -0°C to 50°C. Enclosure size: 355 x 275 x 100 mm. Weight: 2.5 kg.

Analogue fixed temperature linear heat detection system. Heat tracer cable can adapt to a variety of environmental conditions due to built in "self adapting compensation". Early detection of hazards at temperatures well below flame point. Open and short circuit monitoring. All alarm parameters are set on site via special software. Equivalent temperature display. Rugged construction for use in harsh environments. Alarm setting: 68 to 158°C (programmable). Common alarm indication. Recoverable, resettable and testable system. Pre-alarm and alarm outputs (programmable). Fault relay output. Operating temperature: -20°C to 100°C. Cable: high temp PVC.

Ammonia gas detector. Can be used either in a stand-alone mode or connected to Zeta Alarm Systems MGC 126 Multiple Gas Controller addressable panel. Range: 0-100 ppm. Electrochemical sensor. Colour coded for ease of identification. Three programmable alarm levels (indicated by relay outputs) and a 24 V alarm output. Sensor life: 3 years. Operating temperature: 0 - 50°C. Size mm: 130 x 170 x 70.

Methane gas detector. Can be used either in a stand-alone mode or connected to Zeta Alarm Systems MGC 126 Multiple Gas Controller addressable panel. LEL (%): 5.0. Range: 0-100% LEL. Alarm levels: 10-50% LEL. Electrochemical sensor. Colour coded for ease of identification. Three programmable alarm levels (indicated by relay outputs) and a 24 V alarm output. Sensor life: 5 years. Operating temperature: 0 - 50°C. Size: 130 x 170 x 70.

Fire alarm panel, entry level solution for small installations, where traditionally the use of addressable systems would have been considered cost prohibitive. Set of changeover relay output in fault condition. Set of changeover relay output in relay condition. Each detector can have a sounder or combined sounder and flasher base. 2,046 event log (fire and fault). Zone or device disablement. One man test mode. Plug & play, no special tools or laptops for commissioning required. Fully integrated keypad. All associated devices are loop powered. Complies fully to EN54 parts 2 & 4. CE marked.

Ideal entry-level fire alarm panel for small premises that require a fire alarm system. Low cost and simple installation. For larger systems, 4 zone, 6 zone and 8 zone versions are also available. System voltage: 24 V DC (nominal). Operating temperature: -0°C to 50°C. Enclosure size: 355 x 275 x 100 mm. Weight: 2.5 kg.

Control panel designed to fulfil the requirements of EN54 parts 2 & 4. Modular design. Basic panel has 24 zones built in, expandable to 28, 32, 36, 40, 44 and 48 zones by using combinations of M+4Z and M+8Z expansion modules. Does not support zonal alarm circuits. The construction of the panel is epoxy painted steel enclosure, with top and rear cable entries. System voltage: 29 V DC (nominal). Operating temperature: -0°C to 50°C.

Single loop addressable fire alarm panel designed with ease of use in mind. Uses pre-programmed values for its programming options. Configure the loop and enter text labels via the built in keypad, which is optional. Available in 64 or 126 device versions, with a real time clock and 2,048 capacity event log. Connnectable to RS232 desktop printer for real time event log printing. Set of changeover relay contacts for fault condition. Zone or device disablement.One man test mode. Plug & play, no special tools or laptop required. Fully integrated qwerty keypad. All associated devices are loop powered. System voltage: 24 V DC.

Analogue addressable fixed heat detector. Responds with a value of 95 if the detector is triggered through a fixed heat alarm of 90°C. Works with the Zeta addressable protocol. Compatible with all current Zeta analogue addressable control panels. Detector class: fixed heat only. Operating Voltage 17 to 28 V DC (Plus Protocol). Operating temperature -10°C to 50°C. Coverage 50 metre square. Start-up time 30 seconds. Size with base: 101 x 64 mm. Weight with base: 158 g. Comes with a locking grub screw to prevent unauthorised head removal. Complies fully to EN54 parts 5 & 7.

Fire alarm control panel housed in a light gray flame retardant ULV0 enclosure. Designed to meet modern architectural surroundings, with a removable hinged door. Detection zones: 1. Sounder activation delay: 0-9 minutes in 1 minute increments. System voltage: 24 V DC (Nominal). Zone capacity: 32 devices per zone. Enclosure size: 355 x 275 x 100 mm. Weight: 3.25 kg.

Two loop analogue addressable fire alarm panel, designed to be as simple to use as a conventional fire alarm panel. Two addressable loops (divided into 16 zones) and 4 conventional sounder circuits. Supports a serial repeater, includes a real time clock and has 2,048 capacity event log. Loop capacity: 126 devices. Flame retardant ABS plastic. Set of changeover relay contacts for fault condition. One man test mode. Plug & play, no need for any special tools or laptop. Fully integrated qwerty keypad. All associated devices are loop powered. System voltage: 24 V DC.

Analogue addressable rate of heat rise heat detector. Also responds to a fixed temperature of 57°C. Works with the Zeta Addressable Protocol and is compatible with all current Zeta analogue addressable control panels. Detector class: rate of rise and fixed heat. Minimum continuous temperature: 0°C. Coverage: 50 m2. Start up time: 30 seconds. Comes supplied with a locking grub screw to prevent unauthorised head removal. Complies fully to EN54 parts 5 & 7. IP43 protection rating.