Quick and easy way to connect, protect, and program power to emergency vehicle accessories Provides 6 dedicated fused circuits configured in 3 load group to power radios, emergency lights, siren, video, MDT, radar, and more Each circuit is fuse protected with LED indicator which identifies the blown fuse position, simplifying trouble shooting Master Low Voltage Disconnect protects batteries from extreme discharge Heavy duty studs for battery connections Screw terminals for secure load connections Increase circuit capacity by wiring multiple PDS using parallel busing kit Flexible circuit activation/deactivation allows installer to set battery power use priority independently per 2 circuit Load Group: Powered Only With Ignitio Timed Disconnect Always On With Load Group LVD Always On, No Load Group LVD The PDS-100 provides emergency and public safety vehicle electronics installers with a convenient, efficient, safe and dependable method for adding distribution, circuit protection, timer and power control to communication electronics and electrical devices. Its compact size allows installation under consoles and in interior compartments (not intended for installation in engine compartment). As a standalone power distribution system, there is no interference with the vehicles factory installed wire harness; the PDS wires directly to the vehicle battery. Each of the 6 circuits are individually fused (ATO /ATC type) and wired to power-on/fuse fail indicator LED’s which simplifies circuit troubleshooting.
| Make | Kussmaul Electronics Co. Inc. |
|---|---|
| Manufacturer | Kussmaul Electronics Co. Inc. |
| Model code | 390-5711-0 |
| Type | POWER DISTRIBUTION SYSTEM, PDS-100 |
| Additional info |
The PDS-100 provides emergency and public safety vehicle electronics installers with a convenient, efficient, safe and dependable method for adding distribution, circuit protection, timer and power control to communication electronics and electrical devices. Its compact size allows installation under consoles and in interior compartments (not intended for installation in engine compartment). As a standalone power distribution system, there is no interference with the vehicles factory installed wire harness; the PDS wires directly to the vehicle battery. Each of the 6 circuits are individually fused (ATO /ATC type) and wired to power-on/fuse fail indicator LED’s which simplifies circuit troubleshooting. |